Soundoff-signal 400 Series Handheld Amp Box Uživatelský manuál stáhnout pdf

1.800.338.7337 / www.soundoffsignal.com

50A

FUSE

50A

FUSE

Slide Switch Level 3 Output

YELLOW

GREEN

BLUE

RED

GREEN/WHITE

GREEN

RED

GREY

VIOLET

WHITE

Relay #9 Output for

2 wire Arrow Control Interface

Auxiliary Push Button #8

Normally Closed Output

Slide Switch Level Outputs 1-3 and Button Outputs 1-6 are

active high (vehicle supply level).

Wire Length Minimum Wire Gauge

0-10 Feet 10 AW

10-15 Feet 8 AW

15-25 Feet 6 AW

25+ Feet Consult Factory

Wire capacity requirements for Relay

incoming power supply for each wire

Internal Relay Board Fuse replacement:

To replace fuses:

1. Remove power connectors CN8 and CN6 or remove power

to unit.

2. Remove unit from console or obtain access to full top of unit.

3. Depress snaps on top cover and lift open.

4. See chart below for output fuse locations and ratings.

5. Fuse Ratings: Replace with same rated part.

6. Close cover, reinstall connectors and reinstall unit in console.

The button outputs 7 and 8 have the ability to receive power from

an independent external power source or from the internal +V as

supplied to CN8. Both of these outputs use a separate internal

10A mini-ATO fuse which rely on position to determine the source

selection. Each fuse may be placed in one of 2 locations. See

diagram below.

* If the fuse is placed in the fuse holder near the back edge

of the PCB that output will be powered from an external source,

labeled “relay #(x) input” on CN3.

** If the fuse is placed in the fuse holder away from the back

edge of the PCB that output will be powered from the internal +V

source that comes from CN8 pin 5.

**INTERNAL

*EXTERNAL

RED/ BLACK

GREEN/ BLACK

RED/ WHITE

ORANGE

YELLOW

BROWN

BLUE

Auxiliary Push-Button 7 Normally Open Output *

Auxiliary Push-Button 8 Normally Open Output *

Auxiliary Push-Button 7 Normally Closed Output *

Push-Button 4 Output

Push-Button 3 Output

Push-Button 2 Output

Push-Button 1 Output

Slide Switch Level 2 Output

Slide Switch Level 1 Output

+ V

CN3

CN8

CN5

FUSE LOCATIONS ON RELAY PCB

FUSE CHART

LOCATION RATING

FB-8 10A

FB-7 10A

FB-4 10A

FB-3 10A

FB-2 10A

FB-1 10A

FB-5 10A

FB-6 10A

FB-9 10A

FS-1 20A

FS-2 20A

FS-3 20A

AUXILARY PUSH BUTTON

8 7 4 3 2 1 5 6 9

SLIDE SWITCH

1 2 3

Not used

Relay #8 Input

Relay #7 Input

Auxiliary Push Button #6 Output

Auxiliary Push Button #5 Output

RJ45 Cable to Control Panel

400 SERIES AMPLIFIER BOX

PSRN4ANR1

PSRN4ANR2

POWERED

OUTPUT WIRING

ETSA46(x)HPP 3.4.13

CONTROL PANEL

PSRN4CTRL1

HANDHELD REMOTE

PSRNHHC1

5 4 3 2 1

NOTE:

= Not used on Hand Held Version

Right Alley for signle button Alley control

To Device requiring power

only when Ignition Switch

is on

From Siren

Switch Output

+V when Ignition

Switch is ON

NORMALLY OPEN

CONTACT RELAY

1 Amp

NOTICE:

When an output is connected to a

device which is required to function

only when ignition switch is ON, a

relay needs to be installed in-line with

the siren switch output to ensure an

operator can’t activate the device

without the ignition switch ON.

See wiring diagram details:

1 2 3 4 5

Shrnutí obsahu

Strany 1 - 400 SERIES AMPLIFIER BOX

1.800.338.7337 / www.soundoffsignal.com50AFUSE50AFUSESlide Switch Level 3 OutputYELLOWGREENBLUEREDRED GREEN/WHITE GREEN RED GREY VIOLET WHITERelay #9

Strany 2 - HANDHELD REMOTE

1.800.338.7337 / www.soundoffsignal.comInput Settings:1. Press and Hold Auxiliary Button #1 and #3 until LEVEL #3 LED ﬂashes. 1. Park Kill Polarity

Strany 3

1.800.338.7337 / www.soundoffsignal.comMASTER ON / OFF(Siren Standby)Control LEDsAUXILLARY BUTTON #s1 2 34 5 6LEVEL Switches (1,2,3

Strany 4

1.800.338.7337 / www.soundoffsignal.com8Setting PA Volume:1. PA Volume Control (see Input Settings, 1-3) If set to “Programmed”2. Press and Hold A

Strany 5 - ETSA46(x)HPP 3.4.13

1.800.338.7337 / www.soundoffsignal.comETSA46(x)HPP 3.4.139Level Switch Mapping:1. Press Auxiliary Buttons #4 and #5 until RR LED Flashes2. Press

Komentáře k této Příručce

Žádné komentáře

Soundoff-signal 400 Series Handheld Amp Box Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Příslušenství komunikace Soundoff-signal 400 Series Handheld Amp Box. SoundOff Signal 400 Series Handheld Amp Box User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Příslušenství komunikace Soundoff-signal 400 Series Handheld Amp Box